Filter
Top Products
Chapter 5 Configuring Routing Information Protocol
RIP Configuration Quick Start
5-2
Cisco Content Services Switch Routing and Bridging Configuration Guide
OL-4580-01
RIP Configuration Quick Start
Table 5-1 provides a quick overview of the steps required to configure global RIP
attributes for the CSS. Each step includes the CLI command required to complete
the task. For a complete description of each feature and all the options associated
with the CLI command, see the sections following Table 5-1.
The following running-configuration example shows the results of entering the
commands in Table 5-1.
!*************************** GLOBAL ***************************
rip advertise 192.168.1.0 255.255.255.0 9
rip redistribute static 3
rip equal-cost 4
Table 5-1 RIP Configuration Quick Start
Task and Command Example
1. Configure the CSS to advertise a route through RIP.
(config)# rip advertise 192.168.1.0/24 9
2. Configure the CSS to advertise routes from other protocols through RIP
(such as firewall routes, OSPF routes, and static routes configured for the
Ethernet interface ports).
(config)# rip redistribute static 3
3. Set the maximum number of routes that RIP can insert into the routing table.
(config)# rip equal-cost 4
4. (Recommended) Display a RIP configuration for one IP address or all IP
addresses configured in the CSS.
(config)# show rip