Filter
Top Products
Chapter1 Configuring Interfaces and Circuits
Configuring Circuits
1-38
Cisco Content Services Switch Routing and Bridging Configuration Guide
OL-4580-01
Showing IP Interfaces
Use the show ip interfaces command to display configured IP interfaces on the
CSS. The display includes the circuit state, IP address, broadcast address, Internet
Control Message Protocol (ICMP) settings, and Router Discovery Program (RDP)
settings. For example:
# show ip interfaces
Table 1-11 describes the fields in the show ip interfaces command output.
Table 1-11 Field Descriptions for the show ip interfaces Command
Field Description
Circuit Name The name of the circuit associated with the IP interface.
State The state of the IP interface. The possible states are as
follows:
• Active (1) - The interface is up
• Disabled - The interface is disabled
• NoCircuit - The interface is waiting for an underlying
circuit
IP Address The IP address assigned to the circuit.
Network Mask The network mask of the circuit.
Broadcast Address The broadcast IP address associated with the IP interface.
If left at zero, the all-ones host is used for numbered
interfaces. 255.255.255.255 is always used for
unnumbered interfaces.
Redundancy Indicates whether the redundancy protocol is running on
the interface. The default state is Disabled.
ICMP Redirect Indicates whether the transmission of Internet Control
Message Protocol (ICMP) redirect messages is Enabled or
Disabled. The default state is Enabled.
ICMP Unreachable Indicates whether the transmission of ICMP Destination
Unreachable messages is enabled or disabled. The default
state is Enabled.
RIP Indicates whether RIP is Enabled or Disabled.