Filter
Top Products
Chapter 2 Configuring Spanning-Tree Bridging for the CSS
Showing Bridge Configurations
2-6
Cisco Content Services Switch Routing and Bridging Configuration Guide
OL-4580-01
To disable spanning-tree bridging, enter:
(config)# bridge spanning-tree disable
To reenable spanning-tree bridging, enter:
(config)# bridge spanning-tree enable
Showing Bridge Configurations
Use the show bridge forwarding command to display bridge forwarding
information. Table 2-2 describes the fields in the show bridge forwarding
command output.
Use the show bridge status command to display bridge status information.
Table 2-3 describes the fields in the show bridge status output.
Table 2-2 Field Descriptions for the show bridge forwarding Command
Field Description
VLAN The bridge interface virtual LAN number
MAC Address The MAC address for the entries
Port Number The port number used for bridge forwarding
Table 2-3 Field Descriptions for the show bridge status Command
Field Description
STP State The state of the Spanning-Tree Protocol: Enabled or
Disabled.
Root Max Age The timeout period, in seconds, during which the host times
out root information.
Root Hello Time The interval, in seconds, during which the root bridge
broadcasts its hello message to other devices.
Root Fwd Delay The delay time, in seconds, that the root bridge uses for
forward delay.
Designated Root The bridge ID for the designated root.