Filter
Top Products
Chapter 8 Configuring the DHCP Relay Agent
DHCP Relay Agent Configuration Quick Start
8-2
Cisco Content Services Switch Routing and Bridging Configuration Guide
OL-4580-01
DHCP Relay Agent Configuration Quick Start
Table 8-1 provides a quick overview of the steps required to configure the DHCP
relay agent for the circuit. Each step includes the CLI command required to
complete the task. For a complete description of each feature and all the options
associated with the CLI command, see the sections following Table 8-1.
The following running-configuration example shows the results of entering the
commands in Table 8-1.
!*************************** GLOBAL ***************************
dhcp-agent max-hops 10
!************************** CIRCUIT **************************
circuit VLAN2
dhcp relay-to 192.168.22.25
dhcp-relay-agent
Table 8-1 DHCP Relay Agent Configuration Quick Start
Task and Command Example
1. Specify the DHCP relay destination IP address in dotted-decimal notation.
(config-circuit[VLAN2])# dhcp relay-to 192.168.22.25
2. Enable the DHCP relay agent on the CSS circuit.
(config-circuit[VLAN2])# dhcp-relay-agent
3. Set the maximum allowable number in the hops field of the BOOTP header.
(config)# dhcp-agent max-hops 10
4. (Optional) Verify the DHCP configuration.
(config)# # show dhcp-relay-agent global