Filter
Top Products
Chapter1 Configuring Interfaces and Circuits
Configuring Interfaces
1-24
Cisco Content Services Switch Routing and Bridging Configuration Guide
OL-4580-01
Table 1-7 describes the fields in the show phy command output.
Showing Interface Statistics
Use the show mibii command to display the extended 64-bit MIB-II statistics for
a specific interface, or for all interfaces in the CSS. The CSS Enterprise ap64Stats
MIB defines these statistics. The Gigabit Ethernet module port statistics are an
aggregation of all ports on the module.
To display the RFC 1213 32-bit statistics, include the
-32 suffix.
To display extended MIB-II statistics for a specific interface in the CSS, enter the
show mibii command with the interface name. To see a list of interfaces in the
CSS, enter show mibii ?.
Note Refer to the Cisco Content Services Switch Administration Guide for information
on CSS MIBs.
Table 1-7 Field Descriptions for the show phy Command
Field Description
Name The name of the physical interface.
Configured Speed The configured speed for the Ethernet interface (port) in
the CSS. Auto indicates the speed is automatically
negotiated.
Configured Duplex The configured duplex for the Ethernet interface (port) in
the CSS. Auto indicates the duplex is automatically
negotiated.
Actual Speed The actual speed for the Ethernet interface (port) in the
CSS.
Actual Duplex The configure duplex for the Ethernet interface (port) in
the CSS.
Link The link status: Up or Down.
Rev Revision number of the chip.
Partner Auto Indicates whether auto-negotiation is available on the
link partner.