Filter
Top Products
Chapter1 Configuring Interfaces and Circuits
Configuring RIP for an IP Interface
1-42
Cisco Content Services Switch Routing and Bridging Configuration Guide
OL-4580-01
Table 1-12 describes the fields in the show rip command output.
To display global RIP statistics, enter:
# show rip globals
Table 1-12 Field Descriptions for the show rip Command
Field Description
IP Address The advertised RIP interface address.
State The operational state of the RIP interface.
RIP Send The RIP version that the interface sends. The possible values
are as follows:
• none - Do not send RIP packets
• RIPv1 - Send RIP version 1 packets only
• RIPv2 - Send RIP version 2 packets only (default)
RIP Recv The RIP version that the interface receives. The possible
values are as follows:
• both - Receiving both version 1 and version 2 (default)
• none - Receiving no RIP packets
• Ripv1 - Receiving RIP version 1 packets only
• Ripv2 - Receiving RIP version 2 packets only
Default Metric The default metric used when advertising the RIP interface.
Tx Log The setting for the logging of RIP packet transmissions
(Enabled or Disabled). The default setting is disabled.
Rx Log The setting for the logging of RIP packet received (Enabled
or Disabled). The default setting is disabled.