Filter
Top Products
1-19
Cisco Content Services Switch Routing and Bridging Configuration Guide
OL-4580-01
Chapter 1 Configuring Interfaces and Circuits
Configuring Interfaces
Showing Interface Configurations
This CSS includes a series of show interface mode commands that enable you to
view interface configuration information about the CSS. This information
includes VLAN bridging, VLAN trunk status, list of valid Ethernet interfaces,
interface duplex and speed values, interface statistics, and errors on an Ethernet
interface.
This section includes the following topics:
• Showing Bridge Configurations
• Showing Trunking Configurations
• Showing Interface Information
• Showing Interface Duplex and Speed
• Showing Interface Statistics
• Showing Ethernet Interface Errors
Showing Bridge Configurations
The CSS enables you to show bridging information for a specific VLAN in the
CSS. Use the show bridge command to display this bridging information.
The syntax for this command is:
show bridge [forwarding|status] {vlan_number}
The options and variables are as follows:
• forwarding - Displays the bridge forwarding table including the VLAN
number, the MAC addresses, and port numbers.
• status - Displays the bridge spanning-tree status including the Spanning Tree
Protocol (STP) state; designated root; bridge ID; root maximum age; hello
time and forward delay; and port information including state, VLAN, root
and port cost, and designated root and port number.
• vlan_number - Displays the forwarding table or spanning tree status for the
specified VLAN number. To see a list of VLAN numbers, enter show bridge
[forwarding|status] ?