Filter
Top Products
Chapter1 Configuring Interfaces and Circuits
Configuring RIP for an IP Interface
1-40
Cisco Content Services Switch Routing and Bridging Configuration Guide
OL-4580-01
Configuring a RIP Default Route
By default, the CSS advertises a default route on an IP interface with a metric of
1. To advertise a default route on an IP interface with a specific metric, use the rip
default-route command. You can also specify an optional metric in the command
line. The CSS uses this metric when advertising a route. Enter a number from 1
to 15.
For example:
(config-circuit-ip[VLAN7-192.168.1.58])# rip default-route 9
Configuring a RIP Receive Version
By default, the interface receives both RIP version 1 and RIP version 2. To specify
the RIP version that the interface receive, use the rip receive command. The
options for this command are as follows:
• rip receive both - Receives both RIP version 1 and RIP version 2 (default)
• rip receive none - Receives no RIP packets
• rip receive v1 - Receives RIP version 1 packets only
• rip receive v2 - Receives RIP version 2 packets only
For example:
(config-circuit-ip[VLAN7-192.168.1.58])# rip receive both
Configuring RIP Send Version
By default, the interface sends RIP version 2 packets only. To specify the RIP
version that the interface transmits, use the rip send command. The options for
this command are as follows:
• rip send none - Sends no RIP packets
• rip send v1 - Sends RIP version 1 packets only
• rip send v2 - Sends RIP version 2 packets only (default)
For example:
(config-circuit-ip[VLAN7-192.168.1.58])# rip send v1