Filter
Top Products
Reference Information
Reference Guide 7–7
+PSS=
n
0=modems decide whether to use short startup procedures,
2=use full startup procedures on all subsequent connections.
+VCID=
n
Set caller ID reporting: 0=disable (default), 1=enable with
formatted presentation, 2=enable with unformatted
presentation.
+VRID=
n
Report caller ID: 0=use formatted presentation, 1=use
unformatted presentation.
-QCPC Use full startup procedures on next connection, then select
startup procedure defined by
+PQC.
-QCPS=
n
0=do not allow modem to save generated quick-connect profile,
1=allow (default)
&C
n
Set RLSD: 0=always on, 1=follow carrier state (default).
&D
n
0=ignore DTR; 1=upon on-to-off transition, enter online
command state and issue OK result code; call remains
connected; 2=upon on-to-off transition clear call, discard
untransmitted data according to
+ETBM.
&E
n
0=disable line quality monitor, auto-retrain, and auto-rate
renegotiation;1=enable line quality monitor, auto-retrain, and
auto-rate renegotiation (default).
&F0 Restore factory configuration.
&G
n
Included for compatibility only; no effect (returns OK).
&K
n
Set DTE/DCE flow control: 0=disable, 3=enable RTS/CTS
DTE/DCE flow control (default), 4=enable XON/XOFF
DTE/DCE flow control, 5 and 6 included for compatibility only
(no effect, returns OK).
&M
n
Included for compatibility only; no effect (returns result code).
&P
n
Set pulse dial (pps) with make/break: 0=10 pps with 39%–61%
make/break (default), 1=10 pps with 33%–67% make/break,
2=20 pps with 39%–61% make/break, 3=20 pps with 33%–67%
make/break.
&Q5 Select asynchronous operation in error correction mode.
&Q
n
(
n
=0-3, 6) Select asynchronous operation in normal mode
(speed buffering).
Conexant AT Commands (Advanced Users Only)
(Continued)
Command (Conexant)
319954-001.book Page 7 Thursday, February 3, 2005 3:03 PM