Filter
Top Products
Reference Information
Reference Guide 7–9
+MR=0 Disable reporting of modulation connection.
+MR=1 Enable reporting of modulation connection (+MCR: and +MRR:
are transmitted) (default).
+MR=2 Enable reporting of modulation connection (+MCR: and Receive
Rate Only: are transmitted).
+MS=
a,b,c,
d,e,f
Select modulation (
b, c, d, e,
and
f
are optional).
■
a
is the carrier (allowable rates in parentheses):
B103 (300), B212 (1200 Rx/75 Tx or 75 Rx/1200 Tx), V21
(300), V22 (1200), V22B (1200/2400), V23C (1200),
V32(4800/9600), V32B (4800-14400), V34 (2400-33600),
K56 (32000-56000), V90 (28000-56000),
V92 (downstream: 28000–56000;
upstream: 24000–48000).
■
b
is automode: 0=disabled, 1=enabled (default).
■
c
is minimum transmit (Tx) rate (bps).
■
d
is maximum transmit rate (bps).
■
e
is minimum receive (Rx) rate.
■
f
is maximum receive rate (bps).
+WS=
n
Set PDC mode: 1=disable (default), 20=enable.
Conexant AT Commands (Advanced Users Only)
(Continued)
Command (Conexant)
ECC Commands
Command (Conexant)
%C
n
Set data compression: 0=disable, 1=enable V.42 bis and
MNP 5, 2=enable V.42 bis and MNP 5, 3=enable V.42 bis
and MNP 5 (default).
+EB=
a,b,c
Select break handling (
b
and
c
are optional):
■
a
=0 break is ignored.
■
b
=0 transmitted V.42 L-SIGNAL will not indicate break
signal length.
■
c
=0 break is not delivered to DTE.
+EFCS=0 Select 16-bit FCS specified in V.42.
319954-001.book Page 9 Thursday, February 3, 2005 3:03 PM