Filter
Top Products
Compaq Deskpro 2000 Series of Personal Computers 5-31
4. Remove the single screw on the left-rear of the drive that secures the drive into the chassis.
5. Pull the drive straight out of the chassis.
Figure 5-29.
Removing a 3.5-Inch Drive
When replacing either of these drives, transfer the two wafer screws that take the place of drive rails
from the old drive to the new one. There is one wafer screw on each side of the drive at the front.
To replace the 3.5-inch drive, reverse the above procedure.
CAUTION: When servicing the computer, ensure that cables are placed in their proper locations during the
reassembly process. Improper cable placement can damage the computer.
CAUTION: Use only 3/16-inch or 5-mm long screws as guide screws. Longer screws can damage the
internal components of the drive.