Filter
Top Products
42 Cards
4
Disconnect the PS/2 serial-port cable from the system board (see "Mini
Tower Computer System Board Components" on page 13).
5
If necessary, disconnect any external cables connected to the adapter.
6
Ease the PS/2 serial-port adapter bracket out of its slot.
7
If you are removing the adapter permanently, install a filler bracket in the
empty card-slot opening.
NOTE: Installing filler brackets in empty card-slot openings is necessary to
maintain FCC certification of the computer. The brackets also keep dust and
dirt out of your computer and maintain the airflow that cools your computer.
8
Before you close the card retention mechanism, ensure that:
• The tops of all cards and filler brackets are flush with the alignment
guide.
• The notch in the top of the card or filler bracket fits around the
alignment guide.
9
Secure any remaining card(s) by closing the card retention latch and
snapping it into place.
10
Follow the procedure in "After Working on Your Computer" on page 17.
Installing or Replacing a PS/2 Serial-Port Adapter in a Mini Tower
Computer
NOTE: If you are replacing a card, uninstall the driver for the existing card. For
instructions, see the documentation that came with the card.
1
Follow the procedure in "Before Working on Your Computer" on page 9.
2
Remove the computer cover (see "Removing the Mini Tower Computer
Cover" on page 19).
3
Gently lift the release lever on the card retention latch to pivot the latch
open. The latch remains in the open position.
1 card retention latch 2 alignment guide
3 PS/2 serial adapter cable