Filter
Top Products
Storage Array 23
System Setup for Password Reset
Microsoft
®
Windows
®
Operating Systems
1
Click
Start
→
Programs
→
Accessories
→
Communication
→
HyperTerminal
to run HyperTerminal.
If HyperTerminal is not installed, click
Control Panel
→
Add/Remove
Programs
→
Add/Remove
Windows Components
, find
HyperTerminal
and click the check-box, then click
Apply
and
OK
.
NOTE: The original Windows installation disk may be needed to install
HyperTerminal.
NOTE: HyperTerminal is not a component on Windows Server
®
2008 operating
systems.
2
When
HyperTerminal
prompts for a name, type
MD
and click
OK
.
3
Select the COM1 port and click
OK
.
4
Set the following communication settings, click
Apply
, then click
OK
.
Bits per second:
115200
Data bits:
8
Parity:
none
Stop bits:
1
Flow control:
none
LINUX Operating System
The following instructions use the Linux application, MINICOM, to connect
via the serial port:
1
Open a terminal/command window.
2
At the prompt, type
minicom
(all lowercase) and press <Enter>.
3
Once MINICOM is open, press <Ctrl><A>, then <Z>, then the letter
<O> to open the configuration screen.
4
Select
Serial Port Setup
and press <Enter>.
5
Press <F> to change
Hardware Flow Control
setting to
no
.
6
Press <E> to set the
Comm Parameters
.