Filter
Top Products
24 Storage Array
7
Press <I> to set the
speed
to
115200.
8
P
ress <Q> to set the
data
,
parity
, and
stopbits
to
8-N-1
, then
press <Enter>.
9
Press <Enter> to exit the
Comm Parameters
screen.
10
Select Exit and press <Enter> again to exit the setup screen.
Reset Password
NOTICE: Failure to stop data I/O to a non-fault-tolerant array before performing the
following steps may result in loss of data.
1
Stop all I/O to the array.
2
From the HyperTerminal (Windows) or MINICOM (Linux) window, press
<Ctrl><B>.
3
At the
SPECIAL OPERATIONS MENU
, press <1>, <0>, and
<Enter>.
4
At the
SERIAL INTERFACE MODE MENU
, press <1> and <Enter>,
then <Q> and <Enter>.
5
At the
BOOT OPERATIONS MENU
, press <R> and <Enter> to
restart the controller. Text scrolls across the screen as the controller
reboots.
6
Once Controller 0 has fully booted (look for
sodMain complete
in the
HyperTerminal or MINICOM window), press <Enter>.
7
At the prompt, type
clearSYMbolPassword
(must use exact case)
and press <Enter>.
The return
value = 0 = 0x0
indicates that the password has been
reset /deleted.
8
Close HyperTerminal or MINICOM.
9
Remove password reset cable.
10
To set a new password, go to the Modular Disk Storage Manager software
under the
Tools
tab and click
Set Or Change Password Link
.
11
Leave the Current Password blank, enter the new password twice, and
click
OK
.