Filter
Top Products
2 Emphasis User Interface 27
Control fixtures using the encoders (Expression/Insight 3 or 2x with MLM):
Step 1: Press [S8 - Fixture] [x], where [x] is the fixture number you want to select. Use
[And], [Thru] and [Except] to select multiple fixtures. The fixture box will be
displayed.
Step 2: Press [Focus Point] [Enter] to prepare the fixture for control.
Step 3: Press the page keys to move from one encoder page to the next.
Step 4: Spin the encoder corresponding to the attribute you want to change. Attributes
assigned to TX and TY are controlled by a serial trackball or other pointing device
connected to the Facepanel or MLM.
Step 5: Repeat steps 3 and 4 until you have completed all the changes you want to
make.
Control fixtures with the arrow keys (Express & Expression/Insight 2x without MLM):
Step 1: Press [S8 - Fixture] [x], where [x] is the fixture number you want to select. Use
[And], [Thru] and [Except] to select multiple fixtures. The fixture box will be
displayed.
Step 2: Press [Focus Point] [Enter] to prepare the fixture for control.
Step 3: Press up- and down-arrow keys ([
u] or [v]) to move from one encoder page to
the next.
Step 4: Press left- and right-arrow keys ([
s] or [t]) to move to the attribute you want to
change.
Step 5: Use the trackpad or level wheel to adjust the attribute level.
Step 6: Repeat steps 3 through 5 until you have completed all the changes you want to
make.
Fixture
channels
Fixture Box
Encoder assignment Current page
Fixture attribute
16 Bit data