Filter
Top Products
240 Configuring System Information
•
Version —
The version of the current active image.
•
After Reset —
From the menu, select the image that should be active after the next reset.
•
Version —
Displays the version of the image after reset.
Setting the Boot Image Using CLI Commands
For information about the CLI command that performs this function, see the
Configuration and Image
File Commands
chapter in the
CLI Reference Guide
. The following table shows the equivalent CLI
command you use to configure the boot image.
File Download
Use the File Download page to download image (binary) files, SSH and SSL certificates, and
configuration (ASCII), files from the server to the device.
To display the File Download page, click System
→
File Management
→
File Download in the tree view.
Figure 6-107. File Download
The File Download page contains the following fields:
File Type — Select the type of file to be downloaded. Possible filetypes are:
•
Firmware
— Downloads the active image.
Table 6-48. Set Boot Image Command
CLI Command Description
boot system Specifies the system image that the switch loads at startup.