Filter
Top Products
728 Configuring IP Multicast
•
Total Number of Routes
— The number of routes in the DVMRP routing table.
•
Reachable Routes
— The number of routes in the DVMRP routing table that have a non-infinite
metric.
Setting the DVMRP Admin Mode
1.
Open the
DVMRP Global Configuration
page.
2.
Set
Admin Mode
to Enable or Disable, to turn DVMRP on or off.
3.
Click
Apply Changes
.
The DVMRP configuration is saved, and the device is updated.
Configuring DVMRP Using CLI Commands
For information about the CLI commands that perform this function, see the following chapter in the
CLI Reference Guide:
• DVMRP Commands
The following table summarizes the equivalent CLI commands for this feature.
DVMRP Interface Configuration
Use the DVMRP Interface Configuration
page to configure a DVMRP interface. You must configure at
least one router interface before you configure a DVMRP interface. Otherwise you see a message telling
you that no router interfaces are available, and the configuration screen is not displayed.
To display the page, click IPv4 Multicast
→
DVMRP
→
Interface Configuration in the tree view.
Table 12-8. DVMRP Global Commands
CLI Command Description
ip dvmrp S
ets the administrative mode of DVMRP in the router to active.
show ip dvmrp Displays the system-wide information for DVMRP.
ip dvmrp trapflags Enables the DVMRP trap mode.