Filter
Top Products
48 About Your System
Read fault
Requested sector
not found
The operating system cannot
read from the hard drive,
optical drive, or USB device,
the system could not find a
particular sector on the disk,
or the requested sector is
defective.
Replace the optical medium,
USB medium, or USB
device. Ensure that the USB
cables, SAS/SATA backplane
cables, or optical drive cables
are properly connected.
See "Troubleshooting a USB
Device" on page 158,
"Troubleshooting an Optical
Drive" on page 168, or
"Troubleshooting a Hard
Drive" on page 169 for the
appropriate drive(s) installed
in your system.
SATA Port x
device not
found
There is no device connected
to the specified SATA port.
Information only.
Sector not found
Seek error
Seek operation
failed
Faulty hard drive, USB
device, or USB medium.
Replace the USB medium or
device. Ensure that the USB
or SAS backplane cables are
properly connected. See
"Troubleshooting a USB
Device" on page 158 or
"Troubleshooting a Hard
Drive" on page 169 for the
appropriate drive(s) installed
in your system.
Shutdown failure General system error. See "Getting Help" on
page 187.
Sparing mode
disabled. For
sparing mode,
matched sets
of three must
be populated
across slots.
The memory configuration
does not match the setting
in BIOS. The BIOS setting
has been disabled.
Reconfigure the memory
modules for Memory
Sparing mode. See "System
Memory" on page 104.
Message Causes Corrective Actions
book.book Page 48 Tuesday, August 24, 2010 1:47 PM