D-Link DES-3200-10 Switch User Manual


 
xStack
®
DES-3200-10/18/28/28F Layer 2 Ethernet Managed Switch User Manual
2. All ports must be configured as Access Ports or Uplink ports. Access ports can only be Ethernet ports while
Uplink ports must be Gigabit ports.
3. Provider Edge switches must allow frames of at least 1522 bytes or more, due to the addition of the SPVID
tag.
4. Access Ports must be an un-tagged port of the service provider VLANs. Uplink Ports must be a tagged port of
the service provider VLANs.
5. The switch cannot have both Q-in-Q and normal VLANs co-existing. Once the change of VLAN is made, all
Access Control lists are cleared and must be reconfigured.
6. Before Q-in-Q VLANs are enabled, users need to disable STP and GVRP manually.
7. All packets sent from the CPU to the Access ports must be untagged.
802.1Q Static VLAN
This window lists all previously configured VLANs by VLAN ID and VLAN Name.
To view this window, click L2 Features > 802.1Q Static VLAN:
Figure 3 - 6. 802.1Q Static VLAN window - VLAN List tab
To create a new 802.1Q VLAN entry, click the Add/Edit VLAN tab at the top of the window. A new tab will appear, as
shown in the first figure on the next page, to configure the port settings and to assign a unique name and number to
the new VLAN.
To edit an existing 802.1Q VLAN entry, click the Edit button next to the corresponding VLAN entry above. A new tab
will appear, as shown in the second figure on the next page.
See the table on the next page for a description of the parameters of the 802.1Q Static VLAN window’s Add/Edit
VLAN tab.
NOTE: After all IP interfaces are set for configurations, VLANs on the
Switch can be routed without any additional steps.
64