Filter
Top Products
MVME55006E Single-Board Computer Installation and Use (6806800A37D)
MOTLoad Firmware Default VME Settings
64
4.5.1.1 CR/CSR Settings
The firmware supports both Auto Slot ID and Geographical Addressing for assigning the
CR/CSR base address dependent on a hardware jumper setting. See the VME64 Specification
and the VME64 Extensions for details. As a result, a 512K byte CR/CSR area can be accessed
from the VMEbus using the CR/CSR AM code.
4.5.1.2 Displaying VME Settings
To display the changeable VME setting, type the following at the firmware prompt:
z vmeCfg -s -m
Displays Master Enable state
z vmeCfg -s -i(0 - 7)
Displays selected Inbound Window state
z vmeCfg -s -o(0 - 7)
Displays selected Outbound Window state
z vmeCfg -s -r184
Displays PCI Miscellaneous Register state
z vmeCfg -s -r188
Displays Special PCI Target Image Register state
z vmeCfg -s -r400
Displays Master Control Register state
z vmeCfg -s -r404
Displays Miscellaneous Control Register state
z vmeCfg -s -r40C
Displays User AM Codes Register state
z vmeCfg -s -rF70
Displays VMEbus Register Access Image Control Register state
4.5.1.3 Editing VME Settings
To edit the changeable VME setting, type the following at the firmware prompt:
z vmeCfg -e -m
Edits Master Enable state
z vmeCfg -e -i(0 - 7)
Edits selected Inbound Window state
z vmeCfg -e -o(0 - 7)
Edits selected Outbound Window state
z vmeCfg -e -r184
Edits PCI Miscellaneous Register state
z vmeCfg -e -r188
Edits Special PCI Target Image Register state
z vmeCfg -e -r400