Filter
Top Products
12
Setting Up Your Scanner
6. When you return to the Add New
Hardware Wizard, click
Next
.
7. Windows finds the driver for your
scanner and you see this screen:
Click
Next
.
8. After the scanner software installation is complete, the
Screen Calibration utility automatically starts. For the
best results from an EPSON ink jet printer, leave the
default setting of 1.8.
If you are using a different printer or your printouts
don’t match what you see on screen, you can change the
setting. Move the slider to the right or left until the
shades of the horizontal gray stripes appear similar. View
the screen from a short distance. The gray stripes will not
perfectly blend together; however, try to make the two
tones match as closely as possible.
9. Click
OK
to register the calibration setting.
You will not need to change the screen calibration again as long as you
continue to use the same monitor. If you need to recalibrate your screen,
see your electronic
Reference Guide
for instructions.
basics.book Page 12 Tuesday, October 24, 2000 9:53 AM