Filter
Top Products
DXP DVI Pro and DXP HDMI Series • Reference Information 125125
3. Locate the small corner notch on the clear lens cap, and slide the screwdriver between
the lens cap and the diffuser (see
b
in the illustration below).
4. Using a rotating motion of the screwdriver, carefully pry the two pieces apart (see
c
in the illustration below).
5. Lift out the transparent square label that you want to replace, being careful not to
damage the circuits beneath it. You may need to use the small screwdriver to gently
pry the label out.
6. Insert one of the new label you created in step 1 into the clear button cap, align the
white backing plate with the cap, and firmly snap it into place.
7. Gently, but rmly, press the reassembled button into place on the DXP front panel.
8. Repeat steps 1 through 7 as needed to relabel other buttons.
2
3
TEXT
Separating the two-
piece button here at
the corner.
Pry the two
pieces apart.
Diffuser
Plunger
Base
Button Label
Clear Lens
Notch
Figure 116. Replacing a Button Label