Filter
Top Products
DXP DVI Pro and DXP HDMI Series • Operation 14
Secondary functions (
•
):
• Select a global preset (see “Saving and Recalling Presets” on page 32).
• Output 1 only: With the Input 1 button, places the switcher in I/O grouping
mode (see “I/O Grouping” on page 28).
• Mute and unmute an output (see “Muting and Unmuting Video and Audio
Outputs” on page 34).
Configuration Port
c
Config port — This RS-232 port is an alternative to the Remote RS232/RS422
connector on the DXP rear panel (see “Rear Panels” on page 6 for a description). The
port (RS-232 only) can be used for system configuration and control via SIS commands
or the control software. To connect to the Config port, see “RS-232 and RS-422
Remote Connections” on page 10.
Control Buttons
The following table summarizes the primary and secondary functions of the four
control buttons.
Primary Functions
ENTER PRESET
VIEW
ESC
Action: Save changes. Select preset mode. Select view mode. Cancel or escape.
Indication: Blink: Save needed
Blink: Save preset.
Lit: Recall preset.
View the selected
mode.
Flashes once.
Secondary Functions
I/O Grouping
Action/
indication:
Select group 1. Select group 2. Select group 3. Select group 4.
Port
configuration
Action 1: Select Configuration Mode
Action 2/
indication:
Select 9600 baud.
Blink: Selected
Select 19200 baud.
Blink: Selected
Select 38400
baud.
Blink: Selected
Select 115200
baud.
Blink: Selected
Front panel
locks
Action:
With Video and
Audio, select lock
mode 2 or toggle
between modes 0
and 2.
d
Enter button — The Enter button does the following:
Primary functions (❏):
❏ Saves changes that you make on the front panel.
❏ Indicates that a potential tie has been created but not saved.
❏ Indicates that a global preset has been selected to be saved or recalled but that
the preset action has not been accomplished.