Filter
Top Products
c Buffered output — This buffered analog output is
tied only to input 1 and is a direct pass-through from
any video signal, such as composite, S-video, RGBs,
and YUV, that is present on input 1.
Connect a local output to this 15-pin HD (VGA)
connector for a buffered analog output from input 1.
The set signal type is output on the VGA connector,
however, for composite, S-video, RGBs, and YUV signals, break out cables are needed
when connecting a display.
d Input 4 — This port is used to input universal MTP video signals with mono audio
support from an MTP transmitter. The input accepts composite, S-video, component
(bi-level and tri-level), and RGB (RGBHV and RGBS) video signals, but does not support
EDID emulation. When switching to this input, the incoming signal is passed to the
MTP output. The MTP HDMI U R receiver auto-detects the incoming video signal and
outputs it on the appropriate video connector.
The input supports level and peaking adjustment, setting the incoming signal to
appropriate levels.
Skew adjustment is available with this input, compensating for up to 64 nanoseconds
of skew. Adjustments are made using DSP Configurator software or SIS commands.
Settings are stored in the memory and recalled when the input is selected.
NOTE: • See the DSP Configurator Help File "Video Settings" section, or the
"SIS Programming and Control" section for method of skew adjustment.
• This port does not accept RS-232 commands from an MTP transmitter.
Connect to the transmitter by plugging a terminated CAT 5, 5e, or CAT 6 twisted pair
cable into these RJ-45 connectors. The T568A and T568B standard pinouts are shown
below. Use the same standard at both ends of the cable.
Pin T568A Wire Color T568B Wire Color Composite S-video Component RGBHV
1 White-green White-orange Reserved Chroma + R-Y + Red/V. Sync +
2 Green Orange Reserved Chroma - R-Y - Red/V. Sync -
3 White-orange White-green Mono Audio + Mono Audio + Mono Audio + Mono Audio +
4 Blue Blue Video + Luma + Y + Green +
5 White-blue White-blue Video - Luma - Y - Green -
6 Orange Green Mono Audio - Mono Audio - Mono Audio - Mono Audio -
7 White-brown White-brown Reserved Reserved B-Y + Blue/H. Sync +
8 Brown Brown Reserved Reserved B-Y - Blue/H. Sync -
CAUTION: Do not connect the MTP cable to any LAN port, telecommunications
network, or digital video output port.
Do not connect a LAN cable to any MTP or digital video output port.
The MLS-to-MTP input and output transmission distances for CAT 5, 5e, CAT 6, and
CAT 7 cable vary depending on the signal type, resolution and the quality of cable
used. See the table on page 10 for distances.
12345678
RJ-45
Connector
Insert Twisted
Pair Wires
Pins:
1
BUFFERED OUTPUT
CONFIGURABLE ANALOG INPUTS
MLS 608 D Series • Rear Panel Connections 9