Filter
Top Products
RESTRICTED USE ONLY FARGO Electronics, Inc.
Diagnostics and Calibration
Running the Standard Self Test Print
Perform a standard self-test (a) after initial setup of the Printer, (b) after a calibration
procedure has been conducted, or (c) after a part has been replaced to check for proper
operation of the Printer. Review the self-test print below.
Step Procedure
1
Caution: If power is ON, disconnect the power cable from the Printer’s
rear panel. Verify that a full-color ribbon is installed and that cards are properly
loaded.
2 Press and hold the Pause/Resume button.
3 While holding down the Pause/Resume button, plug the power cable back into the
Printer.
4 a. Once the On LED illuminates, release the button.
• The Flipper Table will re-align itself, then the Printer will print a 3-color
process gray scale on the front, flip the card and print the monochrome
black panel on the back. The overlay pass is not printed during the self-
test.
• The card will be ejected with the backside face up.
b. Reverse the card to look at the front side and examine the gray scale pattern
with the green bar at the top (above the EPROM version number) and a red
bar at the bottom of the card.
Reviewing the Standard Self Test Print
v
1
.
0
.
1
Persona® C25 Card Printer User Guide (Rev. 4.0)
57