Filter
Top Products
RESTRICTED USE ONLY FARGO Electronics, Inc.
Card Offset Adjustments
Adjusting the Card Offset for the Print Station
When the factory calibrates the Printer, the output print on the card is centered horizontally.
Caution: For ribbon breakage between the yellow and the clear panel of the
ribbon, or a card jam just as the card is being presented to the Printhead, adjust the card
offset RP3 potentiometer (as needed). See below.
Adjusting the RP3 Card Offset Location
Step Procedure
1 To adjust the RP3 potentiometer counter-clockwise in 1/8
th
turn increments while
running the standard self test, feed more of the card’s leading edge beneath the
Printhead as the card is printed. See the
Performing the Standard Self Test
procedure on page 57.
2 To center the print more precisely on the card, such as printing full edge-to-edge,
use the Printer’s software Driver’s calibration controls. See the
Selecting the
Print Edge-to-Edge checkbox procedure on page 96.
DARKNESS
Rp1
Rp7
OFFSET MAG
OFFSET PRN
RP3
Rp6
OFFSET LAM
Tp5
COLOR
Tp3
Persona® C25 Card Printer User Guide (Rev. 4.0)
68