Filter
Top Products
3-10
Item
Width
Length
Thickness (*1)
Requirements
DL9300 DL9400
Cut sheets (paper table)
55 to 267 mm (2.2 to 10.5 in.) 55 to 420 mm (2.2 to 16.5 in.)
Cut sheets (sheet feeder)
102 to 257 mm (4 to 10.1 in.) 102 to 420 mm (4 to 16.5 in.)
Continuous forms: 102 to 267 mm (4 to 10.5 in.) 102 to 420 mm (4 to 16.5 in.)
Cut sheets (paper table)
70 to 364 mm (2.8 to 14.3 in.) 70 to 420 mm (2.8 to 16.5 in.)
Cut sheets (sheet feeder)
70 to 364 mm (2.8 to 14.3 in.) 70 to 420 mm (2.8 to 16.5 in.)
Continuous forms: 102 mm (4 in.) or greater Same as left
Up to 0.65 mm (0.025 in.)
See Table 3.2 for details.
Notes:
1. The total thickness of multipart paper must not exceed 0.65 mm (0.025in.), with each
part the same size and the part thickness uniform.
2. Multipart paper with a thickness or part count differing from specifications must be
tested before use.
3. The accuracy of line spacing cannot be guaranteed when using multipart paper.
4. Carbon interleaving is used for continuous forms only.
5. Because the carbon inserted between sheets of paper counts as one part, the number of
copies necessarily becomes 3 (in normal mode) or 4 (in multicopy mode) including the
original.
3.7 Details on Forms Specification
The DL9300/9400 processes a variety of forms: letter paper, typewriter paper, copy paper, business stock forms,
labels, and ordinary envelopes. This section gives general specifications for continuous forms and cut sheets.
Before using paper, check that it satisfies the requirements below. For nonstandard forms such as envelopes and
labels, paper of nonstandard size or thickness, or cut sheets for autofeeding using cut-sheet feeders, consult your
Fujitsu representative.
3.7.1 Size and thickness
Table 3.1 Forms size and thickness
*1 The thickness is indicated by the paper weight in grams per square meter or in pounds per bond.