Filter
Top Products
Compliance Statements Introduction
Intelligent Blade Panel Module
9
!
1.2 Compliance Statements
FCC Class A Compliance
This equipment has been tested and found to comply with the limits for a “Class A” digital
device, pursuant to Part 15 of the FCC rules and meets all requirements of the Canadian
Interference-Causing Equipment Regulations. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in strict accordance
with the instructions, may cause harmful interference to radio communications. However, there
is no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between equipment and the receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
Consult the dealer or an experienced radio/TV technician for help.
Fujitsu Siemens Computers is not responsible for any radio or television interference caused
by unauthorized modifications of this equipment or the substitution or attachment of connecting
cables and equipment other than those specified by Fujitsu Siemens Computers. The
correction of interferences caused by such unauthorized modification, substitution or
attachment will be the responsibility of the user.
You may use unshielded twisted-pair (UTP) cables for RJ-45 connections – Category 3 or
greater for 10 Mbps connections, Category 5 for 100 Mbps connections, and Category 5 or 5e
for 1000 Mbps connections.
Wear
an
anti-static
wrist
strap
or
take
other
suitable
measures
to
prevent
electrostatic
discharge
when
handling
this
equipment.
Industry
Canada
-
Class
A
This
digital
apparatus
does
not
exceed
the
Class
A
limits
for
radio
noise emissions
from
digital
apparatus
as
set
out
in
the
interference-causing equipment
standard
entitled
“Digital
Apparatus,”
ICES-003
of
the
Department
of Communications.
Cet
appareil
numérique
respecte
les
limites
de
bruits
radioélectriques
appli- cables
aux
appareils
numériques
de
Classe
A
prescrites
dans
la
norme
sur
le matériel
brouilleur:
“Appareils
Numériques,”
NMB-003
édictée
par
le
ministère des
Communications.