Filter
Top Products
Device Configuration Commands Command Reference
Intelligent Blade Panel Module
152
7.4.1.10 description
This command is used to add a description for the interface.
Syntax
description <string>
<dtring> - Up to 64 characters describing this interface.
Default Setting
None
Command Mode
Interface Config
7.4.1.11 storm-control flowcontrol
This command enables 802.3x flow control for all interfaces on the IBP.
Note: This command only applies to full-duplex mode ports.
Syntax
storm-control flowcontrol
no storm-control flowcontrol
no - This command disables 802.3x flow control for all interfaces on the IBP.
Default Setting
Disabled
Command Mode
Global Config
This command enables 802.3x flow control for the specific interface.
Note: This command only applies to full-duplex mode ports.