Fujitsu BX600 Server User Manual


 
Security Commands Command Reference
Intelligent Blade Panel Module
241
7.9.4.2 radius-server host
This command is used to configure the RADIUS authentication and accounting server.
If the 'auth' token is used, the command configures the IP address to use to connect to a
RADIUS authentication server. Up to 3 servers can be configured per RADIUS client. If the
maximum number of configured servers is reached, the command will fail until one of the
servers is removed by executing the no form of the command. If the optional <port> parameter
is used, the command will configure the UDP port number to use to connect to the configured
RADIUS server. In order to configure the UDP port number, the IP address must match that of
a previously configured RADIUS authentication server. The port number must lie between 1 -
65535, with 1812 being the default value.
If the 'acct' token is used, the command configures the IP address to use for the RADIUS
accounting server. Only a single accounting server can be configured. If an accounting server
is currently configured, it must be removed from the configuration using the no form of the
command before this command succeeds. If the optional <port> parameter is used, the
command will configure the UDP port to use to connect to the RADIUS accounting server. The
IP address specified must match that of a previously configured accounting server. If a port is
already configured for the accounting server then the new port will replace the previously
configured value. The port must be a value in the range 1 - 65535, with 1813 being the default
value.
Syntax
radius-server host {acct | auth} <ipaddr> [port]
no radius-server host {acct | auth} <ipaddr>
<ipaddr> - is a IP address.
[port] - Port number (Range: 1 – 65535)
no -
This command is used to remove the configured RADIUS authentication server or the
RADIUS accounting server. If the 'auth' token is used, the previously configured RADIUS
authentication server is removed from the configuration. Similarly, if the 'acct' token is
used, the previously configured RADIUS accounting server is removed from the
configuration. The <ipaddr> parameter must match the IP address of the previously
configured RADIUS authentication / accounting server.
Default Setting
None
Command Mode
Global Config
7.9.4.3 radius-sever key