Filter
Top Products
Management Commands Command Reference
Intelligent Blade Panel Module
196
Default Setting
Disabled
Command Mode
Global Config
7.5.5.3 snmptrap <name> <ipaddr>
This command adds an SNMP trap name. The maximum length of the name is 16
case-sensitive alphanumeric characters.
Syntax
snmptrap <name> <ipaddr>
no snmptrap <name> <ipaddr>
<name> - SNMP trap name (Range: up to 16 case-sensitive alphanumeric characters).
<ipaddr> - an IP address of the trap receiver.
no - This command deletes trap receivers for a community.
Default Setting
None
Command Mode
Global Config
7.5.5.4 snmptrap ipaddr
This command changes the IP address of the trap receiver for the specified community name.
The maximum length of name is 16 case-sensitive alphanumeric characters.
Note: IP addresses in the SNMP trap receiver table must be unique for the same community
name. If you make multiple entries using the same IP address and community name, the first
entry is retained and processed. All duplicate entries are ignored.
Syntax