Filter
Top Products
Groups Administration
Web-Based Management Interface
Intelligent Blade Panel Module
52
6.2.1.4 Managing Service LAN Groups
6.2.1.4.1. Configuring Service LAN Configuration Page
Selection Criteria
Service LAN Name – You can use this screen to configure an existing Service LAN, or to
create a new one. Use this pulldown menu to select one of the existing Service LAN
Groups, or select 'Create' to add a new one.
Configurable Data
Service LAN Name – Specify the name for the new Service LAN. It can be up to 32
alphanumeric characters, including blanks.
Service LAN ID – the VLAN Identifier for the Service LAN. The range of the VLAN ID is
from 1 to 4094.
Uplink Set Name – Specify the uplink set for the external connection. If the pulldown
menu shows "----------", it means that there is no available uplink set.
Participation – Use the pull-down menu to configure a interface to participate in this
Service LAN. The factory default is ‘Exclude’. The possible values are:
- Include: This interface is the member of the Service LAN.
- Exclude: This interface is not the member of the Service LAN.
Non-Configurable Data
Slot/Port – The interface
Type – The interface type. Type should be internal.
Status –Indicates the current value of the participation parameter for the interface.
Command Buttons
Submit – Update the IBP the values on this screen. If you want the IBP to retain the new
values across a power cycle, you have to perform a save.
Delete - Delete the Service LAN.