Filter
Top Products
Cleaning the Inside of the ScanSnap
329
Turn on the ScanSnap before cleaning the following locations, and clean the following
rollers while rotating them.
• Feed rollers (× 2)
Clean lightly taking care not to roughen the surface of the rollers. Take particular
care in cleaning the rollers since debris left on the roller adversely affects the feed
performance.
• Eject rollers (× 2)
Clean lightly, taking care not to roughen the surface of the rollers. Take particular
care when cleaning the eject rollers since debris on these rollers adversely affect the
pickup performance.
Holding the [Scan] button down for 3 seconds while the ADF top section is open acti-
vates the cleaning mode. In this mode, every time the [Scan] button is pressed, the feed
and eject rollers rotate about 1/6th of a full turn.
3. Close the ADF top section.
⇒ You should hear the ADF top section click when it returns to its original position.
Connect the AC adapter and power cable only when cleaning the feed rollers and eject
rollers.
Make sure that the ADF top section is completely closed. Otherwise, paper jams or
other feeding errors may occur.
ADF top section
ADF paper
chute (cover)