Filter
Top Products
34 Replacing and Adding Internal Devices
5 Disengage the rail locking tabs by pressing in on both front rail
extensions, then move the drive slightly out of the bay by pushing on
the back of the drive.
6 Pull the drive out of the chassis.
7 Remove the rails on both sides of the drive and snap them onto the new
drive in the same positions. The rails are labeled. Make sure the front
rail extensions are towards the front of the drive.
8 Align the rails with the appropriate open bay, then slide the drive into
the bay until the locking tabs snap into place.
9 Connect the power and data cables, making sure the cables are in their
original positions. (See your drive documentation for proper drive jumper
settings and cable orientation.)
10 Close the case. (See “Closing the case” on page 27.)
11 Reconnect the power cord and all other external peripheral devices, then
turn on the system.
Important The rails on the 3.5-inch diskette drive are different from
those on the hard drive and the CD drive. Make sure you
install the correct rails on each drive.
8505945.book Page 34 Thursday, March 9, 2000 2:13 PM