Filter
Top Products
45
Selecting the ANSI Emulation Options
Select ANSI emulation specific options as shown below.
ANSI OPTIONS
To change the ANSI options, press the
ENTER
key to go from the top level to the second
level as shown below. There are 12
options that can be specified
:
Reset Enable
If the printer receives a command (ESC c) from the host to reset the printer, then the
printer will (Y) or will not (N) reset the current configuration to the power-up
configuration.
ANSI OPTIONS
ENTER
ANS: RIS ENABLE
ENTER
ANS:RIS ENBL>Y
↓
ANS:RIS ENBL:N
↓
SI/SO Control
If the printer receives a command (SI or SO) from the host to enable or disable the special
modes (oversize, expanded and bar code modes), then the printer will (Y) or will not (N)
respond to the <SI> and <SO> commands based upon your selection.
ANS: SI/SO CTL
ENTER
ANS:SI/SO CTL>N
↓
ANS:SI/SO CTL:Y
↓