Filter
Top Products
95
Selecting the Special Modes
Select the special modes as shown below.
SPECIAL MODES
To change the special mode parameters, press the
ENTER
key to go from the top level to
the second level as shown below. There are six print mode selections:
Impact Mode
HIG: increases print wire drive pulse width. For heavier multi-part forms you may choose
to select HIGH (print wire) impact mode.
LOW: decreases print wire drive pulse width. For lighter forms or for quieter printing, you
may choose to select LOW impact.
SPECIAL MODES
ENTER
SPEC: IMPACT MODE
ENTER
SPEC:IMPACT>HIG
↓
SPEC:IMPACT:LOW
↓
Quiet Printing Mode
Y: Printing occurs in two passes of print head. For quieter printing (at reduced print
speed) you may choose this mode (QUIET mode).
N: Printing occurs in one pass of print head.
SPEC: QUIET MODE
ENTER
SPEC:QUIET>N
↓
SPEC:QUIET:Y
↓