Filter
Top Products
My HP Brio Doesn’t Start Properly
20
The PC Hangs and Emits Beeps During Startup
These beeps indicate errors in the very early stages of the boot sequence (refer to page 35)
Have you checked that ...
How
Your memorymodules are ofthe correct type
Ö
1 Disconnect the PC’s power cord.
2 Remove the PC’s main cover and lift out the power
supply(seepage51).
3 Replace thememory modulewith aknown working
memory module (see page 65).
4 Reconnect the PC’s power cord and start up the PC.
The expansion card you have installed is
compatible
Ö
1 Disconnect the PC’s power cord.
2 Remove the PC’s main cover (see page 49).
3 Remove the expansion card (see page 66).
4 Reconnect the PC’s power cord and start up the PC.
That you have not made any changes to the
PC’s Setup program that may be causing the
problem
Ö
1 Enter the Setup program by pressing F2 when
prompted during startup. Refer to page 72.
2 Reload the default Setup values by pressing F9.
3 Press F10 to exit Setup saving changes.
I
II
If
ff
ft
tt
th
hh
he
ee
ep
pp
pr
rr
ro
oo
ob
bb
bl
ll
le
ee
em
mm
mp
pp
pe
ee
er
rr
rs
ss
si
ii
is
ss
st
tt
ts
ss
s,
,,
,c
cc
co
oo
on
nn
nt
tt
ta
aa
ac
cc
ct
tt
ty
yy
yo
oo
ou
uu
ur
rr
ra
aa
au
uu
ut
tt
th
hh
ho
oo
or
rr
ri
ii
iz
zz
ze
ee
ed
dd
ds
ss
su
uu
up
pp
pp
pp
po
oo
ort
rtrt
rt p
pp
pr
rr
ro
oo
ov
vv
vi
ii
id
dd
de
ee
er
rr
r
You Get a “non-system disk” or ”operating system not found” Message
Have you checked that ...
How
Youdidn’t leavea non-bootablefloppy diskin
your floppy drive when you started the PC
Ö
1 Check for a non-bootable floppy disk in the floppy
drive.
2 Remove the floppy disk if there is one in the drive.
3 Restart the PC.
The device boot order is correct in the Setup
program
Ö
1 Enter the Setup program by pressingF2 when
prompted during startup. Refer to page 72.
2 Reload the default Setup values by pressing F9.
3 Press F10 to exit Setup saving changes.
The Power-On Self Test Detects an Error
An on-screen error message or more than one beep when the HP Brio starts up means that there is
a configuration problem with your PC. Refer to page 35 for more information on beep codes.
Have you checked...
How
Thepart ofyourconfiguration withwhichthe
Power-On Self Test has detected an error
Ö
For more specific troubleshooting information, refer to
“My HP Brio Detects an Error at Startup” on page 35
If you still have a problem
Ö
Run HP e-DiagTools (refer to page 42)