Filter
Top Products
HP Setup Program
73
•
Boot - for choosing your boot device order and priority.
You can select the order of the devices from which the BIOS (Basic
Input Output System) attempts to boot the operating system. During
the POST (Power On Self-Test), if the BIOS is unsuccessful at booting
from one device, it will try the next one on the Boot Device Priority list
until an operating system is found. The default boot device is the floppy
disk.
•
Exit: for leaving the Setup program.
Setting System Defaults
The Setup program changes system behavior by modifying the power-on
initialization parameters. Setting incorrect values may cause system boot
failure. If this occurs, press the F9 key while you are in the Setup program
to load the Setup program's default values or select Load default values in
the Exit menu of the Setup program. This should enable the computer to
boot properly.
Note If a Supervisor password is set, you need to enter the password to set system defaults.
HP strongly recommendsyou make a note of any changesyoumakewhile inthe Setup program.