Filter
Top Products
Chapter 4 117
Field Replaceable Units
FRU Removal and Replacement
Removable Media Devices
There are only two removable media devices allowed in a B1000/C3000 computer:
• CD Drive
• 3.5-inch floppy disk drive.
The procedures provided in the subsequent sections explain how to install and remove
media devices.
Installing a CD Drive
Install the CD drive by following the procedure covered in this section.
WARNING
Turn the workstation off and unplug the power cord before
installing the CD drive.
Note you will have to verify that the master/slave/CSEL jumper is set in the CSEL
position. Since different manufacturers of CD drives have different locations for the CSEL
jumper, look at the documentation that comes with the CD drive for the proper location of
this jumper.
CAUTION
CD drives are susceptible to mechanical and electronic shock. When handling
the drive, always wear the static-grounding wrist strap that came in the CD
drive kit. Always handle the drive carefully.
1. Perform the procedures in the sections “Opening the System Unit Front Panel” and
“Opening the Left Side Panel of the System Unit.” The front panel must be open to
insert the CD drive into its proper location in the chassis. The left side panel must be
open to access the CD drive ATAPI connector and its power connector.
2. Remove the CD Drive rear cover by unscrewing the T-15 Torx screw as shown in Figure
4-22. Note that the CD drive’s rear cover is located on the rear of the removable media
chassis inside the workstation. Push the cover handle away from the rear of the
removable media chassis approximately one inch. Next pull the cover handle toward
you. The ATAPI data cable, CD audio cable and power cable are now accessible to you.