2. With the right door closed, position the drive assembly near the product, and then rotate it up and
onto the chassis.
NOTE: Make sure that the right-door link arm shaft (callout 1) aligns with and is positioned in
the hole (callout 2) on the arm on the drive assembly, and that the pins on the assembly (callout 3)
are positioned in the holes in the link arms on the chassis (callout 4).
Figure 2-103 Install the main drive assembly (2 of 8)
2
1
3
4
3. Install one screw (callout 1).
NOTE: Do not fully tighten this screw.
Figure 2-104 Install the main drive assembly (3 of 8)
1
168 Chapter 2 Removal and replacement ENWW