Filter
Top Products
Table 3-62 MP modes under the Optimize submenu (continued)
CLEANING CONTROL Changes the control of toner purge. Toner purge is executed
with the CRG in contact with the ITB. Toner purge is executed
right after this mode is selected at the control panel.
ALTERNATIVE 1: Use this option when ITB cleaning failure
occurs during lower coverage printing or when abnormal
noise occurs from ITB cleaning blade.
MEDIA TEMP Use ALTERNATIVE 1to preventing media in the output bin
from sticking together.
UNIFORMITY CONTROL Set to ALTERNATIVE 1 to improve uniformity on any paper
type. Set to ALTERNATIVE 2 to improve uniformity on
normal and light paper types. Set to ALTERNATIVE 3 when
the other alternatives do not correct the problem.
PRE-ROTATION Set to ALTERNATIVE 1 when horizontal banding occurs with
the drum pitch, or when 53 mm band occurs after leaving
engine for a long period of time.
Set to ALTERNATIVE 2 when the problems like fade finger
(trailing edge toner starvation) occur after high coverage
continuous printing.
REGISTRATION Set to ALTERNATIVE when color misregistration occurs.
TRANSFER CONTROL Set to ALTERNATIVE 1 to reduce primary transfer bias and
to resolve low density or blotchy images. Set to
ALTERNATIVE 2 to resolve ghosting outlines that look like a
finger or fingers. Set to ALTERNATIVE 3 when the other
alternatives do not correct the problem.
MOISTURE CONTROL Set to ALTERNATE when image failure occurs due to water
drops.
ENWW
Use manual print modes
523
ALTERNATE
ALTERNATE
ALTERNATE 1, 2, AND 3
ALTERNATE 1 AND 2
ALTERNATE
ALTERNATE 1, 2, AND 3