Filter
Top Products
32.21.00
Description
Corrupt firmware in external accessory
Recommended action
Turn the product off, then on, and retry.
If the error persists, clear the firmware image from the active partition by using the Partial Clean item
in the Preboot menu
40.00.01 USB I/O buffer overflow To continue, press OK
Description
The USB buffer has overflowed.
Recommended action
Press the OK button to print the transferred data (some data might be lost).
Check the host configuration.
40.00.02 Embedded I/O buffer overflow To continue, press OK
Description
The product has experienced a JetDirect buffer overflow.
Recommended action
Press the OK button to print the transferred data (some data might be lost).
Check the host configuration.
40.00.03 EIO buffer overflow To continue, press OK
Description
Too much data was sent to the EIO card in the specified slot (x). An incorrect communications protocol
might be in use.
Recommended action
Press the OK button to print the transferred data (some data might be lost).
40.00.04 Unsupported USB accessory detected To continue, press OK
Description
The connection between the product and the USB device has been broken.
430 Chapter 3 Solve problems ENWW
33.02.01
Description: Used board
disk installed. A used
formatter or hard disk from
an existing printer has
been placed in this printer.
Recommended Action:
Reinstall the used board or
disk back into its original
printer.