Filter
Top Products
Chapter 4
Removal and Replacement
Removing and Replacing a PCI Card
83
Step 13. Connect all cables to the replacement PCI card.
Step 14. In SAM’s Replace Card window, click the
OK button.
SAM powers the PCI slot back on, and turns off (stops blinking) the slot’s attention indicator. SAM
also resumes the card’s drivers.
Step 15. Confirm that the replacement card is online and powered in, using SAM’s I/O Cards screen.
Step 16. Synchronize the PDH and I/O card SCSI parameters.
1. When powering up system, go into CO (console window). When POST finishes running, the
system displays the Main Menu (the system is at BCH at this point in time).
2. From the Main Menu enter ser. This takes you to the Service Menu.
3. At the Service Menu prompt enter scsi default. The system then informs you that it will
clear (reset) all scsi paths and prompts you to enter either Yes or No.
4. Enter y. The system takes a few seconds to reset the scsi ports, list all the ports with the reset
values, then displays the Service Menu prompt.
5. Reboot the system.