Filter
Top Products
Chapter 1
Introduction
Detailed hp rp7405/rp7410 Description
15
Figure 1-10 Right-Front View of hp rp7405/rp7410
The PCI I/O card section, located towards the rear, is accessed by removing the top cover.
The PCI OLR fan modules are located in front of the PCI cards. These six 9.2 cm fans are housed in plastic
carriers. They are configured in two rows of three fans.
The MP/SCSI MP Core I/O boards are positioned vertically at the rear of the chassis.
The PCI card bulkhead connectors are located in the top rear portion of the product volume.
Four OLR system fan modules, externally attached to the chassis, are 15 cm (6.5-inch) fans. Two fans are
mounted on the front surface of the chassis and two are mounted on the rear surface.
Redundant line cords attach to the floating AC connector module at the bottom rear. Two 20-amp cords are
required to power the server. Two additional line cords provide redundancy.
A cable harness that connects from the rear of the BPSs to the system backplane provides DC power
distribution.
Access the system backplane is accomplished by removing the left side cover. The system backplane inserts by
a guide/insertion mechanism using a single large jack screw assembly.
SCSI ribbon-cable assemblies route from the mass storage area to the backside of the system backplane and
to the Procurium PCI MP Core I/O card.
Bulk powers supplies
Slide
PCI DC-to-DC
converters
PCI cards
Cell boards
Front panel
display board