Filter
Top Products
Chapter 2
Installation
MP Core I/O Connections
39
On the front of the hp rp7405/rp7410, a solid green Standby Power, a solid green MP Present, and a
flashing amber Attention light will illuminate after about 30 seconds.
Figure 2-22 Front Panel Display
2. Check the bulk power supply LED for each BPS.
When on, the breakers distribute power to the BPSs. AC power is present at the BPSs:
• When power is first applied. Note the BPS LEDs will be flashing amber.
• After 30 seconds has elapsed. Note the flashing amber BPS LED for each BPS becomes a flashing
green LED
Refer to power cord policies to interpret LED indicators.
3. Login to the MP:
a. Enter Admin at the login prompt. This term is case sensitive.
It takes a few moments for the MP prompt to appear. If it does not, make sure the laptop serial device
settings are correct: 8 bits, no parity, 9600 baud, and na for both Receive and Transmit. Then, try
again.
b. Enter Admin at the password prompt. This term is case sensitive.