Filter
Top Products
8. Close the ink cartridge latch. If the cartridge is inserted correctly, closing the latch
gently pushes the cartridge into its cradle compartment. Press the latch to make
sure it is seated flat on the cartridge.
9. Repeat if necessary for the other ink cartridge.
10. Close the front access cover and plug the power cord into the back of the device.
11. Wait for the carriage to complete the ink cartridge initialization routine and return to
the home position at the left side of the printer before using the printer.
NOTE: Do not open the front access cover until the ink cartridge initialization
is complete.
12. Align the ink cartridges. For more information, see Align the ink cartridges.
Replace the ink service module
The replaceable ink service module holds waste ink from the black ink cartridge. When
the ink service module is almost full, the printer lights prompt you to replace it. For
more information, see
Control panel lights reference. When you are notified by the
control panel that the ink service module is full, contact HP support to obtain a new
module. For more information, see
HP support. If you have a new ink service module,
install it immediately by following the instructions that came with the module.
TIP: When the ink service module is full, the printer stops printing. However, until
the replacement arrives, you can continue printing by removing the black ink
cartridge and printing with just the tri-color ink cartridge. Color results and print
speeds, though, might be affected. For more information about printing with a
single ink cartridges, see
Print with a single ink cartridge.
CAUTION: Allowing the ink service module to fill completely can result in black ink
spillage. Take care to avoid spilling the ink in the ink service module. Ink can
permanently stain fabric and other materials.
Solve paper-feed problems
For information on resolving jams, see Clear jams.
This section contains the following topics:
•
Media is not supported for the printer
•
Media is not picked up
•
Media is not coming out correctly
•
Pages are skewing
•
Multiple pages are being picked up
Media is not supported for the printer
Use only media that is supported for the printer and the tray being used. For more
information, see
Media specifications.
Solve paper-feed problems 57