Filter
Top Products
End Raster
Graphics
Command
The End Raster Graphics command signifies the end of a
raster graphic data transfer.
? * r C
Receipt of this command causes 5 operations:
Resets the raster compression seed row to zeros.
Moves the cursor to the raster row immediately following
the end of the raster area (if a source raster height was
specified).
Allows raster commands which were previously locked
out to be processed.
Sets compression mode to 0 (no compression).
Defaults the left graphics margin to X-position 0.
Note This command is a modified version of the ?*rB End
Raster Graphics command. The newer version (?*rC)
performs two additional operations: it resets the
compression mode to 0 and defaults the left graphics
margin to 0.
This command (?*rC) is not supported by the HP
LaserJet III or the HP LaserJet IIID printers. Use the
?*rB End Raster Graphics command to terminate raster
graphic data transfers for these printers.
Refer to the “PCL Feature Support Matrix” in Chapter 1
of the PCL 5 Comparison Guide for specific printers
which support these commands.
Raster Graphics 6-39Raster Graphics 6-39