Filter
Top Products
Removal and Replacement
Procedures
Removal and Replacement of Components 107
Optical Drive
To remove an optical drive:
1. Disconnect power from the system (page 79), remove the access panel (page 86), and remove the
front bezel (page 87).
2. Disconnect the audio
1, data 2, and power 3 cables from the drive. The connector colors might be
different than illustrated.
NOTE: The audio cable is only required for Linux-based systems.
3. Lift the green drivelock release lever
1 and gently slide the drive out 2 of the chassis.
4. If not installing another optical drives, replace the bezel blank.