Filter
Top Products
Removal and Replacement Procedures86
Access Panel
Before accessing the internal components of the workstation, the access panel must be removed.
To remove the access panel:
WARNING! Before removing the workstation access panel, be sure that the workstation is turned off and
that the power cord is disconnected from the electrical outlet.
1. Disconnect power from the system (page 79) and lay the workstation on its side as shown.
2. If necessary, unlock the access panel (page 84). The keys are on the rear panel.
3. Pull up
1 on the handle and lift off 2 the cover.
To replace the access panel, slide the cover back on until it snaps into place.