Filter
Top Products
Status byte 10
Table 23. Status byte 10
Bit Description
0 (LSB) Reserved
1 Electronic journal suspend (see driver spec for electronic journal support)
2 Set when responding to checksum request for download graphics logos or
stored messages.
3 Reserved
4 Reserved (Always = 0)
5 Reserved
6 Reserved
7 (MSB) Reserved
Status byte 11
Table 24. Status byte 11
Bit Description
0 (LSB) CR feed error - no motion detected when line feeding.
1 Reserved
2 Detected partial paper cut. Cutter may be failing.
3 Unexpected cover open. This bit will be set when the cover is open,
where there isn't an error condition.
4 Reserved (always = 0)
5 Cutter jam. CANNOT print in the CR station when this bit is set.
6 Set to 1 when CR paper is low.
7 (MSB) Set to 1 when CR paper is critically low.
Status byte 12
This will contain information RMA should monitor.
Table 25. Status byte 12
Bit Description
0 (LSB) Reserved
1 Document feed slip detected. Document
does not appear to move as far as it should
when feeding. Tested during MICR read and
landscape print.
2 Reserved
3 Unexpected DI cover open. This bit will be
set when the cover is open and there has not
been an error.
4 Reserved (Default = 0)
5 High voltage detection. The printer will be
offline if this bit is set.
6 Reserved
Chapter 5. Status information 93